Hello,Welcome to YiMing!
With the increase of extrusion parts output in China, the development of the industry is very fast, mainly due to China's unique market advantages. Aluminum alloy die castings are widely used, especially in the automotive industry, the demand for aluminum alloy die castings is very large. The automobile industry in our country has been developing rapidly in recent years. The demand for aluminum alloy die castings has been increasing rapidly, which has greatly promoted the development of aluminum alloy die castings industry in china. Especially in the light of the trend of automotive lightweight, there is a huge demand for the global aluminum alloy die casting market, not to mention the demand for the automotive industry in our country. At the same time, due to the optimization of auto industry upgrading, is gradually used Aluminum Alloy castings instead of castings, so as to continuously stimulation on Aluminum Alloy casting demand growth. The automobile industry is still in the stage of continuous development for our country. Under the impetus of the above trends, the advantages of our country's aluminum alloy die castings industry are very obvious.
For the recent market suddenly gone, experts remind, should pay close attention to the final whereabouts of the machine, is to investors, intermediate vendors, or the ultimate user's hands? People should have a good attitude towards the normal pace of development, in the future extrusion machine parts industry should not appear excessive growth situation. The financial policy and loan conditions remained unchanged, and fiscal policy remained steady. Even if the country wants to "protect" the industry, under the unified government order, it is also very uncomfortable to special care. Funds generally tight, is the industry's vast majority of enterprises are facing one of the big problems. At the same time, the profit continues to decrease, the bumper harvest is not bumper to bumper harvest, under these multiple factors' function, is more obvious. The industry concerned outstanding debt problem to the managers, it is suggested that enterprises boycott to alleviate the financial pressure on credit.
As the traditional extruder parts are full hydraulic and curved elbow two different models, in the traditional common die casting without distinction, but if used for extrusion die casting is different. In conventional die casting and extrusion die casting, casting during filling, extrusion die-casting adds a master cylinder power forward step up the common casting is only natural cooling, no fill shrinkage step. The traditional die casting machine directly applies the extrusion die casting technology, and can only use its clamping force, and only the clamping force is a driving force forward. The magnitude of the die force determines the size of the extrusion force. Therefore, the clamping force of a full hydraulic press is its clamping force, and it can also be used as its extrusion force. The forward extrusion force of a curved die casting machine is equal to the force of the clamping cylinder force multiplied by the lever ratio of the locking mechanism, but it can not exceed the compressive strength that the clamping mechanism can bear.
This year, extrusion parts industry may be a relatively low level in recent years. Especially since the first half of last year have been too much reason, the first half of this year a few months before the situation is not optimistic. In addition, some agents reflect the payment is better than last year, installment payments reduced, brand concentration increased significantly. This period of time may affect the market pattern throughout the year. According to estimates, the national fixed asset investment growth rate has now exceeded 26%. Because of its high degree of international monopoly, so once rising, it is difficult to fall back, this cycle is not 5 to 10 years is not easy to complete. Strict control of housing prices has become the focus of a new round of regulation and control. In recent years, the overheated real estate situation has reached the point of strict control. The impact of real estate construction on the extrusion machine parts industry may not be immediate, but it should not be neglected. It has become the focus of the government's economic work to curb the rapid rise in the prices of the means of production and the prices of real estate.
